CCNP
　　- BSCI
　　6.You are troubleshooting BGP on your routers. You must check of a particular router is a route reflector or not. Which IOS command should you use?　　A. show bgp neighbor
　　B. show running-config
　　C. show route-reflector
　　D. show route-reflector-client　　7.You must redistribute BGP routes into an IGP protocol, for example OSPF or EIGRP.What should you take into　nsideration?
　　A. IGPs are limited to 250 routes
　　B. A full BGP routing table may contain 100,000+ routes
　　C. Because of possible routing loops, Cisco router configuration does not allow BGP routes to be restributed into an IGP.
　　D. Because BGP routes are not advertised unless they are known by the IGP, Cisco automatically redistributes routes into GPs.　　8.Your router has been configured with the manual route summarization of 153.25.200.0/21. Which of the following addresses would be included in the route summarization?
　　A. 153.25.198.0
　　B. 153.25.206.0
　　C. 153.25.208.0
　　D. 153.25.224.0　　9.You are configuring your OSPF router network. You separate a large area into multiple smaller areas. What is phrase used for this action?
　　A. interior areas
　　B. OSPF subarea
　　C. link-state protocol
　　D. hierarchical routing　　10.You are troubleshooting one OSPF router. In particular you want to identify which networks are routed by a given OSPF
process. What IOS command should you use?
　　A. show ospf
　　B. show ip route
　　C. show ip protocols
　　D. show ip ospf database
　　-BCMSN　　11.Which of the following items should be an integral part of a network topology diagram? (Choose all that apply.)
　　A. Individual end user systems.
　　B. Location of configuration files.
　　C. Illustrations of each network device.
　　D. Representations of logical and physical connections.
　　E. Speed and duplex of individual switch ports.　　12.There are three destinations to which the Cisco router logging process can distribute error messages. What are these three destinations? (Choose all that apply.)


   本篇文章共3页，此页为首页   下一页